Autel Support Communities
Autel Support Communities
Welcome, Guest     Sign in
Communities > Diagnostics > USA Cars > keep getting programming error e4399 whi...
keep getting programming error e4399 while trying to program tcm on 06 chevy hhr

2380 Views 3 Replies Latest reply: 2017-02-28 17:48:12


  •   Level 1   
    (5) points
    jrjauto
    2017-02-25 15:05:14
     keep getting programming error e4399 while trying to program tcm on 06 chevy hhr has anyone else encountered this problem

  •   Level 7   
    (817) points
    spikeoo7

    2017-02-25 16:52:27 (Reply to:jrjauto)

     call tisweb hot line at 1888-212-8959, option 2 and provide the error code.

  •   Level 2   
    (12) points
      Key Fobs Inoperative, TPM System Not Reading Correctly - Dashes On All Four Tire Readings, DTCs C0775, C0569, B3105 Set, Unable to Program TPM Sensors (Reprogram RCDLR)

    TECHNICAL SERVICE BULLETIN

    Reference Number(s): 08-03-16-001B, Date of Issue: July 31, 2008 Affected

    2008 Chevrolet Cobalt, HHR, Malibu; 2008 Pontiac G5, G6, Solstice; 2008 Saturn AURA, SKY Model(s):

    This bulletin is being revised to update the Important statement to reflect the new direction to no Supercedes: longer contact TCSC. Please discard Corporate Bulletin Number 08-03-16-001A (Section 03 - Suspension).

    CONDITION

    Some customers may comment that the key fobs are inoperative or that the TPM system is showing dashes as the reading for all four tires.

    Technicians may find DTCs C0775, C0569 and B3105 set simultaneously in the RCDLR module.

    In addition, the technicians may find Tire Pressure Monitoring sensors are unable to be programmed to the vehicle by adding or releasing pressure to the tire while the vehicles in the TPM learn mode.

    CAUSE

    These conditions may be caused by the following:

    The RCDLR may lose its transmitter and tire pressure monitoring data from its memory if a low voltage condition occurs on the vehicle.

    The ability for TPM learning by adding or releasing pressure to the tire has been disabled in the RCDLR.

    CORRECTION

    Reprogram the RCDLR with an updated software calibration to address both issues listed above. This new service calibration is available on TIS2WEB using Service Programming System (SPS). As always, make sure your Tech 2® is updated with the latest software.

    IMPORTANT:

    If the Tech 2® could not establish communication with the RCDLR AND the programming event ended with error, attempt to reprogram in Service Programming System (SPS) by selecting "Remote Control Door Lock Receiver (TSB 08-03-16-001) with E4399 error - Pass Thru Only".

    Once the RCDLR module has been reflashed with the latest software and calibrations, the following may also be necessary:

    Relearn all keyless entry transmitters.

    Reconfigure the tire pressure placards and the tire type.

  •   Level 7   
    (817) points
    buddy no offense, great post , but how is this related  to the original post?
1
  Total1 Pages