Having replaced the injectors on a 2007 Mitsubishi L200, I set about programming the new codes. The Maxisys read the previously stored codes fine and allowed me to enter the new codes. However, once I pressed OK to write the new codes, it returned saying it couldn't proceed "negative password".
I tried it a couple of times through different menu screens (that display the inj. programming option) but without success - each time returning the failed message.
Anyone else had this or is there a solution ?
The vehicle won't run for more than 2 seconds with the new injectors fitted and it sounds like it's running on Ether (i.e. horrible!).
Many thanks