I am having a problem with a 2006 Lincoln Mark Lt. The Engine was replaced 1 year ago with a reman. and i have not had any problems until now. The problem i am having is that the engine will start and then stall, after it stalls i can restart the vehicle and it will stall again. I hooked up the autel ms906bt and can run vehicle with the fuel pump turned on all the time and it runs fine. I already changed the FPDM and still have the same problem. The live data reads as followed, Fuel Level 58.48, Fuel Pump 1 off, Fuel pump 2 75%, Fuel pump fault None, Fuel Rail Pressure Desired 57.2 psi, Fuel rail pressure Transducer status No Faults, FPR 1 43.42psi, FPR 2 2.98v, Fuel Rail Temp. 1 69.8 deg., Fuel Rail Temp. 2 3.17v, Fuel Rail Temp. Sensor Status No Fault, Fuel System Status Open Loop, Fuel tank Pressure -.64 psi, Fuel Tank Pressure 2 0.12v, Fuel Tank transducer Status No Fault, Fuel Tank Pressure displayed as inches of water -17.62, Fuel pump Monitor 0 psi. All live data was without engine running.