Hi. The vehicle: 2001 Ford F 150- Super Crew
Trying to perform a Key Programming procedure which I,m able to access the Key delete and prog. It goes thru all the motions and when I cycle the two keys no keys are programmed. Tried several times to no avail.
Procedure indicated by the MS908 pro
Position the key to off position
Disconnect the j2534 from the obd2 socket
Cycle key no.1 to Run position for 3 secs
Cycle key no.2 to Run position for 3 secs
Cycle key no.1 to Run position for 3 secs
Two key should be now programmed
When I complete the cycle, the theft warning light still there and the vehicle cranks but wont start.
Its the first time it happens to me after successfully performing many of these key programmings.
Could this be a bad PATS module? Any help is appreciated.