Hello,
I can't finish injector programming. Peugeot Boxer ecu Visteon 2.2puma. Injectors Denso. All repaired new codes. Codes accepted but then when it comes to finish pilot injection, it fails. All condition for doing this checked. Temp 70°C or over, air temp also over 30°C. I also tried the codes from old injectors but it was the same problem. When I check injector programming status it reads not started ( electrical charge too high). Does anyone succefully finish injector learning procedure on this car? I want to be sure it is not the diagnostic software issue.
Thanks
Martin

Tags: 2.2 , puma , injector , learning