Autel Support Communities
Autel Support Communities
Welcome, Guest     Sign in
Communities > MaxiCheck > Airbag/ABS > AL619 ABS/SRS
AL619 ABS/SRS

4904 Views 4 Replies Latest reply: 2014-10-02 17:25:28


  •   Level 1   
    (8) points
    gijoey
    2014-02-17 10:35:38
      I just received my scan tool this weekend. I plugged it into the DLC on my 2000 BMW 323 (E46). I tried to retreive the ABS and the SRS codes (both lights are on) but tool states "tester not communicating with controller". Do I need to update the NEW tool ?

  •   Level 1   
    (3) points
    flyhal

    2014-02-24 15:11:18

    I have the same problem on my 1999 Z3. It should be finding the abs k-line 9141-k2 for those codes. But it will not link. The engine k-line links with no problem. I have an adapter cable that connects the 2 k-lines to pins 7&8 and the L-line on pin15. Also battery and ignition +12 volt lines. It appears that the MS609 scanner is not set up for earlier BMWs with the round plugs or the 9141-2k bus for ABS.  When I purchased the scanner I had understood it would do then ABS for the OBD2 system BMW.  -   flyhal@yahoo.com

  •   Level 1   
    (6) points
    Cyclone

    2014-04-30 20:04:08

     I have the 619 and am using it with a 2003 Subaru Forester XS (2.5L, 4-speed automatic), my 619 also reports that it cannot communicate with either the SRS or ABS sensors.  I have updated to the latest Subaru software from the Autel website (v. 2.30) , eventually going as far as reformatting the MicroSD card and then reinstalling all the relevant software...it made no difference.

    I started a tech support "issue" ticket, and it's looking like I'm being blown off -- their reply below:

    "I have talked with our field engineers.

    We have done the 2003 subaru forester ABS and SRS system in the field, so we are pretty sure it is using the KWP protocol and we are capable of testing it.

    In your case, there may be two reasons for not communicating.

    1.       Your Subaru is manufactured for  some special areas.

    2.       Pls check if the ABS circuit is fine.

      Autel Support"

    Nice...



  •   Level 1   
    (3) points
    pppham

    2014-09-01 10:00:58 (Reply to:gijoey)

     did you have your issues resolved.  I just got my AL619.  Is working great on my Benz S500 (reset SRS and got active code for ABS) and my LR Disco 2 (reset the 3 amigos and brake).  However, it will not communicate with my E46 330CiC.

  •   Level 1   
    (6) points
    millstream

    2014-10-02 17:25:28 (Reply to:pppham)

     I too just got an AL619 and cannot communicate with SRS controller on my 2009 toyota tacoma; other comm is ok.
1
  Total1 Pages