Smartire TPMS
1864 Views 0 Replies Create Time: 2019-07-01 23:47:28
-
Level 2
(19) points
Below is the instructions to program an Autel MX Sensor for Smartire (Aston Martin DB9).The instructions shows 7 digits, which is consistent with the sensor. However, the programming feature on the TS401 only has 6 digits. Any advice on how to do this?Autel Support sent me the below instructions for programming a 433 MHz Autel MX sensor to support a Smartire system.
Relearn Procedure:
Please note:
If new ID is created for the this sensor, OE tool is needed to perform relearn.
With Autel tools, the only solution is to copy the OE Sensors' IDs, and no relearn needed.
There are two methods to copy the OE sensors' IDs.
Method 1:
1. Please perform a rapid tire deflation while pressing the trigger button on Autel tool to receive sensor data.
2. Then use the 'Copy By Activation' function to program Autel sensor.
3. Install the duplicated Autel sensor to the location corresponding to the OE sensor.
Method 2:
1. Uninstall the OE sensor, a series of numbers (173-1-1-XXXXXXX)�are printed on its surface, among which XXXXXXX is the OE sensor's decimal ID.
2. Use the 'Manual Create' function to program Autel sensor.
3. Install the duplicated Autel sensor to the location corresponding to the OE sensor.
Note:
If necessary, please pay special attention to the sensor ID format conversion when using the 'Manual Create'.
1
Total1 Pages
- Related links
-
Top users
-
Online users
-
Search Communities