I received my MP408 scope yesterday and have been playing around with it. So far I am impressed with the features and the way the scope works.
Reading the manual, I can only find reference to the PC software (which is not currently available), nothing mentioned about using the MaxiSys app. I was looking for what the top left button does (car with gear). The button is grayed out and does not seem to do anything. Also the help button does not work.
One issue I have noticed is when using the measurement rulers, if your selected probe is x10 or 20:1 attenuator, the measurement ruler windows does not show the correct voltage, it is not accounting for the x10 or x20 probe setting. The voltage on the main scale and measurement is adjusted correctly just not the rulers.
When I was reading the specs a few months back, I thought the timebase range was a misprint "100ns/div to 1000s/div". This is correct, however that makes each division approx 16 minutes and the screen timebase is then 2.6 hours? Not sure when you would use this but slower timebases around 1 sec is handy.
I also ordered 2 Hantek current probes (CC-65 and CC-650) which look the same as the ones in the Autel advanced kit. Both probes are in the probe selection window of the scope app and seems to work well (only tested CC-65 so far). As with issue above, amp measurement ruler is not adjusted correctly either.
I will send these issues to support and see what they say.
Looking forward to PC software as it looks like it has even more features.