Hi guys my neighbor just purchased a 2014 m6 132,000.00 black convertible....He backed it out the garage and ofcourse I had to come over. I drive a highly modified Jaguar XJR ..I asked if he would allow me to scan the car with my ms905 and he did.. The car had no mil on the cluster but had 9 subsystem codes.I am sure just voltage related since car was just sitting on the lot, and I cleared them.But I wanted to add that Autel is really putting effort into the new models software..For each code it gave a lead for cause and where to look , and which tests may need to be carried out.This is very close to GT1. It was very detailed..That was the newest bimmer I ever scanned with my Maxysis and it was very good. I have scanned 2000's to 2012 and it isnt the same detailed code info...The actuation capacity was great ,headlight,seat,covertible top,tpm system,abs,dsc,nav,cluster sweep,bluetooth, turning signals,brake lights,ac,wipers,and horn and much more covered with actuation.Smooth running values covered,and thats about all I had a chance to test..But the scanner gave me lots of confidence about the newer models of bimmers that we all will encounter eventually with our scanners, But the thng that impressed me the most was the test leads for possible fault codes.To close, yes this scanner has some glitches at times,and will almost make you want to smash it lol , but I tell ya it is very good in so many ways and the good outweighs the bad over and over....Good job Autel!