3828 Views 4 Replies Latest reply: 2014-08-08 06:54:01
Can anyone advise how to write vin and Pin number to a new WCM in order to correct the vin mismatch code.
I found "replacing skreem and win module under body control but I could not get to a transfer of vin or a place to write the vin. I cannot program the key until I write the vin. I have the pin number. Vehicle is a 2006 Jeep Liberty.
Thanks!
Thanks for the reply, but it is a WCM on the 05-07 Liberty. It is not a Skim, Skreem, or WIN. It is located where the skim module would be, ( around the ignition lock cylinder). I did try the menu that you list above under skim /skreem replacement and win replacement, however, it would not transfer the vin on the new module until I entered the 4 digit Pin Number. I read the Pin from the logic chip on the bad module and had it ready to enter, but I could not because of the vin mismatch error. It was like a catch 22.
I have performed the vin transfer on a WIN module.--- Again this is a WCM, I just programmed keys on a 05 today and it is listed as a WCM on the Chry Part Number sticker, on the immobilizer module.
Thanks