5117 Views 27 Replies Latest reply: 2016-04-29 16:29:35
-
Level 10
(10965) points
Hi, if Guidance function is available then it will login automatically. But if guidance function is not available, there is instruction of security code when clicking security login. For ECU of the same type the security code is the same. Thanks! -
Level 2
(42) points
I tried but i found when the maxisys show the login code ,the vcds show too ,my vision is V5.31,at the same not all the system when i use the security login it will show the login code . the both two -
Level 8
(2559) points
i allways use VCDS not maxisys for any coding some modules you only get one shot to code... -
Level 4
(122) points
But is it possible somehow to get one more shot to code, already coded (used one) module? For example airbag module? Because I tried on my passat and it was written, ''Airbag module already coded''. So how can I code it again? -
Level 8
(2559) points
like i said some modules you only get one shot.....but in any case you need to login to change the coding once you have done that select do-it -
Level 2
(42) points
-
Level 8
(2559) points
here is an example from ross-techCoding
VAG-COM will automatically tell you a suggested coding (HEX interface required), otherwise contact us for assistance.
Adaptation
Used to deactivate individual airbag components (see repair manual for details).
Basic Setting
Seat Occupied Recognition Control Module (J706)
If the Seat Occupied Recognition Control Module (J706) or the seat itself have been replaced, the basic setting has to be performed.
[Select]
[15 - Airbags]
[Security Access - 16]
Enter 30475 or 20324 to enable the basic setting. Note: It is unclear which of these is correct; it seems there may be two different variants of these modules, using two different Security Access codes, and we are not sure how to tell which one is which.
[Do it!]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The reset has been performed.
[Done, Go Back]
[Close Controller, Go Back - 06]
Special Procedures
Seat Occupied Recognition Control Module (J706): Reset
If a repair on the Seat Occupied Recognition has been performed, a reset has to be performed too.
Prerequisites:
- Seat in normal position.
- Seat must NOT be occupied during the whole procedure.
- Seatbelt must NOT be plugged in.
- No faults in the system.
- Interior temperature must be between 0 °C and 37 °C (32 °F and 98 °F).
[15 - Airbags]
[Security Access - 16]
Enter 30475, to enable the basic setting.
[Do it!]
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]
-
Level 4
(122) points
- Related links
-
Top users
-
Online users
-
Search Communities