I am trying to program the key Fobik for a 2006 Grand Caravan with the DS708 and cannot get access to any type of programming whatsoever.  I've gone into the BCM and looked for anything related to key programming and cannot find anything.  Is this key able to be programmed using the DS708.  

-

Also are you sure that's a 2006 caravan

 hello, francisco

a question that years have programmed keys and if the maxisys WCM module and searched but not been successful

 i have the correct pin, can connect to the old skreem but it has a bad antanne. the 708 says incorrect pin when i connect the new skreem. dealer says the pin stays the same when replacing module. maybe the 708 cannot setup and write the vin to the new module only will program keys ?
i have done the with a pt cruiser (program key with the pin) and it worked fine. just cannot access a new skreem.
anybody else seen the before ?

Yes the pin code is the same its genarated by the vehicles vin number. What vehicle is
this your trying to program? Model year etc. Which module,modules have you
replaced? Also keep in mind the pcm and skeem,wcm,win can not be replaced at the
same time or the transfer of te secret key will fail. Make sure the vin number writen in
the pcm is the same vin number of your vehicle before you install and program
skeem,wcm or the wrong vin will be writen to the skeem,wcm which can only be
writen once any other than that if the proscess fails then is safe to say is a tool or
software issue good luck.

 Thank you very much for the very detailed instructions, Ede65!

 Del,

How did you program the PIN on the 708?