3136 Views 1 Replies Latest reply: 2016-11-12 04:17:48
Just installed firmware version 3.12.
Your previously saved Settings will be over written, so after installing this firmware update, I highly recommend immediately using the Settings Menu and change the following settings:
Backlight Set – Change from ‘OFF’ to ‘ON’.
Pressure Unit – Change from ‘BAR’ to ‘kPa’ or ‘PSI’.
ID Format – Change from ‘DEC’ to ‘Hex’. This should eliminate an annoying scrolling effect of the displayed sensor ID number.
This firmware version fixes all minor firmware bugs which I had noticed in previous firmware versions. It also brings back the program display feature which shows cumulative tire pressures at each wheel on a car graphic which is shown while using the wheel sensor scanning procedure. That graphic feature had been missing since firmware version 2.68.