I did a quick clear of all the codes of an auto scan today on a 2005 Honda Accord and now I have the yellow triangle with exclamation mark illuminated in the middle of the instrument cluster just like what happened on Acura TL.
I tried to do the VSA Neutralization Procedure using the DS 708 (called Nuetral function , that resets 3 sensors) and there is a selection on menu on bottom to short SCS but couldn't get DS 708 to successfully reset the sensors.Trying the steps below. Maybe I'm doing something wrong? Has anyone ran into this after clearing codes in ABS/TCS/VSC module needed to perform the Neutral function and it works on DS708?
1. Park the vehicle on a flat and level surface.
2. With the ignition switch OFF, connect the HDS to the 16P date link connector (DLC) (A) under the driver's side of the dashboard.
Fig 1: Connecting HDS To 16P Date Link Connector (DLC) Under Driver's Side Of Dashboard
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Short the SCS circuit using the HDS.
2006 Acura TL 3.2L Eng
Page 1 of 2Printer Friendly View
2/15/2016http://www1.shopkeypro.com/Print/Index?content=article&module=false& tab=false&term...
4. Turn the ignition switch ON (II) with the brake pedal position switch released.
5. The ABS indicator comes on for 2 seconds and goes off.
6. After the ABS indicator goes off, press and release the VSA OFF switch once within 0.5 seconds.
7. After the ABS indicator comes on, press and release the VSA OFF switch once within 0.5 seconds.
8. The VSA activation indicator blinks two times and goes off in 1 second, then the system completes the VSA sensor neutral position memorization.
9. When the ABS indicator, VSA indicator and VSA activation indicator go off, the memorizing is done. If the indicators do not go off, retry these steps.
10. Turn the ignition switch OFF, and disconnect the HDS from the 16P DLC.