I had seat belt codes for driver seatbelt, seatbelt tensioners / driver and passenger, replaced them and crash sensors on rad support replacing them with knee airbag under drivers wheel, left hand drive . I'm getting 25.5 ohm on airbag loop stage 1 and 2 now, all other codes have been cleared and reading 2.5 ohm or less ! I was under impression Maxi Sys Elite w/ J2534 programmer and GM / A/C Delco web site can reset airbag module after repairs are completed , correct me if I'm wrong, please I'm in proses of checking clock spring for open loop now