2012 chevy cruze SRS
2370 Views 4 Replies Latest reply: 2016-04-21 03:51:20
-
Level 2
(14) points
I'm having trouble with airbag system, I'm getting codes P0012 -04 & P0013 -04 and I replaced the 2 sensors on radiator and steering wheel airbag and clock spring and still saying loop open ! any help please, and thank you !I'm using MaxiSYS Elite with J2534 -
Level 2
(13) points
Did you replace the airbag module or have it sent out and rebuilt or check your seat
belts
-
Level 2
(14) points
I had seat belt codes for driver seatbelt, seatbelt tensioners / driver and passenger, replaced them and crash sensors on rad support replacing them with knee airbag under drivers wheel, left hand drive . I'm getting 25.5 ohm on airbag loop stage 1 and 2 now, all other codes have been cleared and reading 2.5 ohm or less ! I was under impression Maxi Sys Elite w/ J2534 programmer and GM / A/C Delco web site can reset airbag module after repairs are completed , correct me if I'm wrong, please I'm in proses of checking clock spring for open loop now -
Level 6
(475) points
i have had codes like this on many gm cars. open or close driver airbag circuit. and it was the shorting bar in the airbag connector or the srs plug going to the clock spring. i just pulled the shorting bar out and codes went away. -
Level 2
(14) points
thank you all , it was a bad clock spring !! I found by testing ! thanx again
1
Total1 Pages
- Related links
-
Top users
-
Online users
-
Search Communities